Jaguar X350 Lower Mesh Grille
- Description
- Fitting Guide
- Reviews
For a truly dashing and sporty finish, fit a stainless steel mesh grille to the lower air intake.
These lower grilles are made from the same high quality electro-polished, hand-woven stainless steel mesh as used for the upper grilles and will complement each other perfectly enhancing your car’s appearance.
The grille for the X350 model is designed to neatly wrap around the fog lamps. The grille can be installed in minutes, directly replacing the standard plastic bar. Full fitting instructions are provided.
These lower grilles are made from the same high quality electro-polished, hand-woven stainless steel mesh as used for the upper grilles and will complement each other perfectly enhancing your car’s appearance.
The grille for the X350 model is designed to neatly wrap around the fog lamps. The grille can be installed in minutes, directly replacing the standard plastic bar. Full fitting instructions are provided.
- Begin by removing the black plastic located either side of the fog lamps. These should quite simply pull out.
- Once removed you will need to remove the plastic bar fixed in the centre of the bumper - this is held in place with 2 hexagonal screws.
- Offer the grille up to the opening in the bumper, and push the grille back into position.
- Ensure the grille is pushed back as far as it will go, and until it makes contact with the centre bar on the bumper.
- Once correctly in position, make sure the sides are also pushed back as far as they can go over the back edge of the bumper and locate correctly.
- At the top corner of the grille there is a clip that goes through a hole in the bumper, ensure this is located to fully complete installation.
Follow us